New WizFi360-EVB-Shield View larger

WizFi360-EVB-Shield

WizFi360-EVB-Shield

New product

WizFi360-EVB-Shield is a development board for experiment, test and verification of WizFi360. WizFi360-EVB-Shield can also be used as an Arduino shield. WizFi360 is a low cost and low-power consumption industrial-grade WiFi module. It is compatible with IEEE802.11 b/g/n standard and supports SoftAP, Station and SoftAP+Station modes. The serial port baud rate can be up to 2Mbps.

More details

HKD218.40

Add to wishlist

Data sheet

Operation Temp (℃)-40 ~ 85
Operation ModeStation / SoftAP / SoftAP+Station
Wireless Standard802.11b/g/n, 2.4G

More info

WizFi360
  • WiFi 2.4G, 802.11 b/g/n
  • Support Station / SoftAP / SoftAP+Station operation modes
  • Support “Data pass-through” and “AT command data transfer” mode
  • Support serial AT command configuration
  • Support TCP Server / TCP Client / UDP operating mode
  • Support configuration of operating channel 0 ~ 13
  • Support auto 20MHz / 40MHz bandwidth
  • Support WPA_PSK / WPA2_PSK encryption
  • Serial port baud rate up from 600bps to 2Mbps with 16 common values
  • Support up to 5 TCP / UDP links
  • Obtaining IP address automatically from the DHCP server (Station mode)
  • DHCP service for Wireless LAN clients (AP mode)
  • Support DNS for communication with servers by domain name
  • Support “Keep-Alive” to monitor TCP connection
  • Support “Ping” for monitoring network status
  • Built-in SNTP client for receiving the network time
  • Support built-in unique MAC address and user configurable
  • Support firmware upgrade by UART Download / OTA (via WLAN)
  • Industrial grade (operating temperature range: -40 ° C ~ 85 ° C)
  • CE, FCC certification
ETC
  • Built-in UART to USB chip
    • CP2104-GM
    • Micro USB B Type Connector
  • UART Selector
    • JP1, JP2, JP3
    • 2.54mm Pin Header
  • Built-in Sensors
    • Temprature/Humidity Sensor: DHT11
    • CDS Sensor: GL5537
  • Built-in Tact Switchs
    • System Reset Switch: S1
    • WiFi Reset Switch: S2
  • Built-in LED Indicators
    • D13 LED
  • Built-in Level Shifters
    • The voltage of the RXD/TXD signal changes according to the main board platform voltage.
  • Built-in DIP Switchs
    • UART RXD/TXD Selector: SW1
    • UART RTS/CTS Selector: SW2
    • Sensor/RESET Pins Selector: SW3

Reviews

No customer reviews for the moment.

Write a review

WizFi360-EVB-Shield

WizFi360-EVB-Shield

WizFi360-EVB-Shield is a development board for experiment, test and verification of WizFi360. WizFi360-EVB-Shield can also be used as an Arduino shield. WizFi360 is a low cost and low-power consumption industrial-grade WiFi module. It is compatible with IEEE802.11 b/g/n standard and supports SoftAP, Station and SoftAP+Station modes. The serial port baud rate can be up to 2Mbps.