W5500 Ethernet Shield

New product

W5500 Ethernet shield is designed using the WIZnet W5500 chip. Please click the link for the further information about W5500. It supports both 3.3V & 5V. This Ethernet Shield is compatible with Arduino and ARM mbed Platform.

More details

In stock

HKD179.00

Add to wishlist

Volume discounts

QuantityPriceYou Save
5 HKD171.60 Up to HKD37.00

More info

Overview

  • ARM mbed compatible operation
  • Arduino Pin-compatible
  • Ethernet (W5500 Hardwired TCP/IP chip)
Features
  • Suppport 3.3V / 5V
  • High Speed Ethernet controller W5500 chip
  • SPI interface
  • Internal 32Kbytes Tx/Rx buffer
  • 10/100 Ethernet PHY embedded
  • Support Auto Negotiation (Full / Half duplex, 10 / 100-based)
  • Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
  • User Selectable GPIO pin
  • Support SD-card slot for storage
  • Support I2C, UART interface

Hardware Configuration

  • RJ-45 with Transformer : Ethernet Port
  • W5500 : a hardwired TCP/IP Ethernet Controller
  • RESET : Reset Ethernet shield and Arduino when pressed
  • SD-Slot : support Micro SD card in FAT16 or FAT32 ; (Please Read the Caution)
  • I2C : I2C interface
  • UART : UART interface

Available Board List

  1. ARM mbed Board
  2. Arduino Board
  3. Arduino-compatible Board

Getting Started

  • You need Update to Use W5500 Ethernet shield Included Arduino IDE (Sketch Program) of WIZnet Ethernet shield (Required)
  • Check this below.
Pins usage on Arduino & ARM mbed

W5500 Ethernet shield is User Selectable GPIO

  • The user is able to use different Modules by changing Chip Select
  • Stackable : Possible to stack different modules
  • Arduino compatible INTn pin is D2(2,3 Short). So, if you need INTn pin. You soldering to 0R Resistor to Dx pin

Caution: When the user uses 5V Platform, we cannot confirm a stable operation of SD-CARD. Therefore, though 5V Platform is safe to use after going through enough tests, it is highly recommended to mount buffer & 100nF Capacitor for a secure operation.

SPI Operation & Timing Diagram

SPI Operation

There is a W5500 inside W5500 Ethernet shield. Therefore SPI operation & Timing Diagram of Ethernet shield follows one of W5500. For more information about W5500chip please also refer to the chip's data sheet in the download section.

Technical Reference

Block Diagram

  • Not buffer

  • Using buffer

Rev 1.0 Schematic

Rev 1.01_europe Schematic

  • You want to develop new this product? Please look Rev 1.01_europe circuit

  • Rev 1.01 is Remove to buffer in Rev 1.0 circuit

  • Because, limited buffer delay speed

  • Arduino compatible INT pin(R25 to v1.0) remove

Part list

Dimension

  • W5500 Ethernet shield Rev1.0 Dimension

Reviews

No customer reviews for the moment.

Write a review

W5500 Ethernet Shield

W5500 Ethernet Shield

W5500 Ethernet shield is designed using the WIZnet W5500 chip. Please click the link for the further information about W5500. It supports both 3.3V & 5V. This Ethernet Shield is compatible with Arduino and ARM mbed Platform.

Accessories

Download